| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Automatic Transmission/Transaxle | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000010N901WX |
| Title: A750F AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the switch to the manual valve shaft.
|
(b) Temporarily install the bolt. |
|
(c) Install a new lock washer and the nut. Torque: 6.9 N·m (70 kgf·cm, 61 in·lbf) |
|
(d) Temporarily install the control shaft lever RH. |
|
(e) Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position. |
|
(f) Align the groove with the neutral basic line. |
(g) Hold the switch in position and tighten the bolt.
Torque: 13 N·m (133 kgf·cm, 10 ft·lbf)
|
(h) Using a screwdriver, bend the tabs of the lock washer. |
|
|
(i) Install the transmission control shaft lever RH with the spring washer and nut. Torque: 16 N·m (163 kgf·cm, 12 ft·lbf) |
(j) Connect the switch connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the cable with the nut.
Torque: 14 N·m (143 kgf·cm, 10 ft·lbf)
NOTICE:
When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle.
3. INSPECT SHIFT LEVER POSITION
4. ADJUST SHIFT LEVER POSITION
5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
|
|